API standard 650 horizontal tank shell compression

Welding of Large Steel storage tank Primary Components
a)Longitudinal and circumferential shell joints and joints that connect the API standard 650 horizontal tank annular bottom plates together.
b)Joints that connect sections of compression rings and sections of shell stiffeners together. Backup bars may be used for these joints with complete penetration and complete fusion detail.
c)Joints around the periphery of a shell insert plate.
d)Joints that connect the shell to the bottom, unless a method of leak checking is used (see Q.8.2.1).

The outer FRP of API 650 oil tank will not produce electrolytic corrosion with groundwater and brine. The outer FRP will not corrode with gasoline, diesel oil and leaded gasoline API standard 650 horizontal tank. The leakage detector can monitor the whole process 24 hours to eliminate the potential pollution. The leakage detection system is convenient for the inspection and maintenance of API 650 oil tank, and protects the original ecological environment of soil and groundwater.

Tunisia cutomer purchased around 1500 tons 304L,310S stainless steel plate from us and make tanks in August, 2017. The company was skilled in the design and manufacture of stainless steel tanks, API standard 650 horizontal tank processing systems and equipment for the food, dairy, beverage, chemical, pharmaceutical, biotechnology, and pure water industries. They also sent the inspection team come our company and visited our production line. After using our stainless steel plate, the customer was very satisfied with our products.

Prefabrication requirements for API standard 650 horizontal tank, large vertical storage tanks:
1. The machined surface of the edge of the steel plate should be smooth, and there should be no defects such as slag inclusion, delamination, cracks, etc., and the surface hardened layer produced by the flame cutting groove should be removed.
2. Dimension deviation after steel plate processing: the deviation of plate width is less than 1.5 mm, the deviation of plate length is less than 2 mm, and the difference between diagonals is less than 3 mm.

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.