API standard 650 aluminum tanks with flat bottoms

Welding of Large Steel storage tank Primary Components
a)Longitudinal and circumferential shell joints and joints that connect the API standard 650 aluminum tanks annular bottom plates together.
b)Joints that connect sections of compression rings and sections of shell stiffeners together. Backup bars may be used for these joints with complete penetration and complete fusion detail.
c)Joints around the periphery of a shell insert plate.
d)Joints that connect the shell to the bottom, unless a method of leak checking is used (see Q.8.2.1).

Prevent the storage liquid from impacting the inner wall of the API 650 petroleum storage tank or increase the internal pressure, reduce the corrosion of the tank top and the tank wall, and extend the service life of the API standard 650 aluminum tanks storage tank.

We supply 3500 tons SA387GR5CL1 steel plates to Pakistan. The main businesses of the Pakistan customer are manufacturing columns & towers, heat exchanger, waste heat recovery boiler, pressure vessel & reactors, tanks, etc. We arranged SGS test for the SA387GR5CL1 steel plates. The test contents include chemical composition analysis, tensile test, impact test, etc. The test results are satisfied. The Pakistan customer gave good feedback after receiving the SA387GR5CL1 steel plates.

High temperature heat transfer oil fin tube heating device for large API standard 650 aluminum tanks has the advantage of high heat transfer efficiency. The high-temperature heat-conducting oil finned tube heating device adopts high-efficiency outer finned tubes. The outer finned tube coils are immersed in a water bath. Compared with ordinary light tubes, the contact area between the evaporation coils and the medium is increased. The total heat transfer coefficient of the coil is determined by the heat transfer coefficient outside the tube. This increases the heat flux per unit tube length and improves the overall heat transfer efficiency.

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.