5456 aluminum bar API standard 650 insulated tanks

The company has a perfect after-sales service system and quality assurance system. The company adheres to the service principle of "all for users", and has established a professional after-sales service team. In the future service process, the after-sales service adopts regular return visit for customers. Timely understand the customer's satisfaction with our products, and solve the user's problems at any time.Temporary Openings after Hydrostatic Test
When approved by the Purchaser in writing, and only in the case of tanks which when complete have no shell penetrations, it is permitted to restore by welding up to four temporary shell openings after the hydrostatic test in accordance with the provisions of this section. Each temporary opening shall be restored by the insertion of a shell plate that matches the thickness and specification of adjacent shell material, and is welded into place with full fusion butt-welds. The API standard 650 insulated tanks insert plate shall be round with diameter no less than 24 in. and no greater than 42 in.Oil, Gas, Chemical, Water, and Bio-Fuel storage. Maximum of the most common welded steel tanks used in industry are designed following API 650. Tanks typically found in Refinery API standard 650 insulated tanks tank farms, Terminals, Pipelines, and other process facilities use these tanks.Strengthen system construction. The system itself has a certain binding force, which specifies the rights and obligations of employees. It is a passive management means for employees. Its purpose is to promote each employee to develop good professional habits, form good behavior norms, and promote the improvement of enterprise management level.Deformation of the welding seam of the API standard 650 insulated tanks is a common quality problem during the actual use of the API standard 650 insulated tanks, which easily causes the tank body to leak and affects the safety of the oil storage tank. The welding seam deformation of the API standard 650 insulated tanks is mainly caused by the lack of reserved welding seam gap and irregular operation. The oil storage tank has not reserved the corresponding weld gap, resulting in deeper root removal during the front welding activity. The heat output of the weld will increase under the influence of a long time, and the deformation of the weld will gradually become serious.