API 650 aluminum storage tanks flat-face pipe flange
In addition to the requirements of API Standard 620 tank Appendix Q.8.1, the nameplate shall be attached to the tank at an accessible location if it is outside of any insulation or protective covering of the tank. The nameplate for the inner tank shall be located on the outer tank wall but shall refer to the inner tank. The nameplate, if any, for the outer tank of a double-wall tank shall be located adjacent to the nameplate or the inner tank and shall refer to the outer tank.
Welded steel API 650 aluminum storage tanks storage tanks that are designed, manufactured and installed on the ground are classified according to the API standard system. The three API standards API 650 aluminum storage tanks all adopt on-site production and installation of storage tanks.
In December, 2018, our Vietnam customer purchased 352 tons SA387Gr12Cl2 and SA387Gr11Cl2 API 650 aluminum storage tanks steel plates for their tank fabrication project. The customer need those cargo urgently, and we keep many stock in warehouse , it only takes about 3days we collect total cargo for shipping to customer. The customer are very appreciate our quality and service. They API 650 aluminum storage tanks become our regular customer and repeat order to us every month.
}The bottom plate of the vertical API 650 aluminum storage tanks directly contacts with the foundation soil, which is suitable for the flexible foundation, and its settlement characteristics are quite different from that of the rigid foundation. For the settlement calculation of the foundation of a vertical API 650 aluminum storage tanks, the one-way compression layered sum method can be used. The calculation method is to divide the foundation soil into several layers of compression within the calculation depth of the foundation settlement, and then find the sum. The calculation method of the compression amount of each layer is the same as the calculation method of the compression amount under the condition of no lateral deformation.
When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.
