EN S355J0 plates API 650 stainless steel storage tanks

Stamping of API 620 storage tank PlatesBefore plates required to be stamped by the steel mill are used, the inspector shall see that they bear the stamp. In laying out and cutting the API 650 stainless steel storage tanks plates, at least one set of the original material identification markings should, if possible, be left where it will be plainly visible when the tank is completed. Should the identifying marks be obliterateSpot radiographic or ultrasonic examination shall be not less than 6 in. extending along the weld. Spot radiography shall comply with the standards given in 7.15.1.3. Where spot radiographic or ultrasonic examination is applied at joint intersections, the surface shall be prepared and examined for a distance of 3 in. on each side of the intersection, making the minimum length of examination 6 in. on the horizontal weld and 3 in. on the vertical weld.

The API 650 stainless steel storage tanks most widely used and most commonly used standard for global storage tank construction and procurement is API 650. The Chinese translation name is "AP1650 Steel Welded Petroleum Storage Tank". API 650 storage tank is for commonly used oil, gasoline, diesel, chemical and production water storage, etc.

In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.

}

Crack treatment of API 650 stainless steel storage tanks weld area: find out the crack tip with ray or ultrasonic flaw detection, drill cut-off holes at both ends of the crack with the cut-off method, the hole depth is slightly greater than the crack depth, or groove (crack stop groove) is made by angle grinder at both ends of the crack, shovel and grind the whole crack, and grind it into a suitable groove; use radiographic inspection and dye detection to verify that the crack has been completely excavated, and finally repair welding.

Customer first, reputation first, high-quality and perfect after-sales service is the extension of our product value and an important guarantee for the interests of customers. The purpose of our API 650 stainless steel storage tanks service quality management system is to establish and constantly improve a scientific, reasonable and efficient service quality management system, and complete the after-sales service quality guarantee work of customers fairly, accurately and timely, For our company's API 650 stainless steel storage tanks customer service to establish a good, comprehensive, full service system.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!