EN 10025 S275J2 plates API Std 650 anchored tanks

The company has a group of experienced steel plate continuous processing line construction, production management, operation and professional and technical personnel. The company is a modern enterprise integrating scientific research and development, production processing, sales and service. Our main products include hot rolled plates, seamless pipes, API Std 650 anchored tanks and steel structures. At the same time, it also adheres to international standards and adheres to the international line.Structural shapes of 9% and 5% nickel steel may be furnished to the chemical and physical requirements of ASTM A353, A553, or A645. Physical tests shall be in accordance with the requirements of ASTM A6.
API Std 650 anchored tanks used Piping, Tubing, and Forgings
Material used for piping, tubing, and forgings shall be compatible in welding strength, and thermal expansion coefficient with the tank shell material. In addition to the specific requirements of this appendix, all piping within the limitations of 1.3.2 shall fulfill the minimum requirements of ASME B31.3.The effect of air pressure on the API Std 650 anchored tanks tank walls of the API 650 tank must be considered when the design pressure is greater than 2 kPa.The fixed point method can be used to design the tank wall of atmospheric or micro internal pressure API Std 650 anchored tanks storage tank.Advanced typical figures and typical deeds are the embodiment and symbol of API Std 650 anchored tanks enterprise spirit, outstanding ideas and vivid images, with strong demonstration, radiation and transmission effect. Without distinctive typical characters, there is no unique enterprise culture. In carrying out the construction of enterprise culture, the advanced enterprise culture should be typified. Vigorously excavate, discover, cultivate and summarize the company's API Std 650 anchored tanks advanced models.Welding inspection of bottom plate of API Std 650 anchored tanks, vertical oil tank: During the fabrication and installation of API Std 650 anchored tanks, the bottom edge plate is welded first. According to the requirements of the technical standard, penetrant inspection is required for the weld of edge plate at the bottom of API Std 650 anchored tanks, that is, penetrant testing is required for each weld bead priming, filling and capping. In the process of testing, if any defect is found, it shall be repaired immediately. After the repair, the surface coloring penetrant test shall be conducted again until the test result is qualified.