API 650 flat-bottom steel tanks roof venting

Allowable Design Stresses
The maximum allowable design stresses for the API 650 flat-bottom steel tanks materials outlined in Q.2.1 shall be in accordance with Table Q-3.The values for the allowable design tensile stress given in Table Q-3 for materials other than bolting steel are the lesser of (a) 331/3% of the specified minimum ultimate tensile strength for the material or (b) 662/3% of the specified minimum yield strength, but they are 75% of the specified minimum yield strength for the stainless steel, nickel alloy, and aluminum materials. Allowable test stresses are based on the limitation of API 620 oil tank storage standard Q.8.1.3.

The API 650 tank Standard has the built in flexibility to be used in building tanks to store a wide variety of products while ensuring the structural stability of the API 650 flat-bottom steel tanks tank.

In 2015, we participated in an tender for oil and casing pipe in Pakistan. Because of our professional service and company strength. The end user chose us as the final contractor of the project of 22000 meters pipes of different sizes production. It takes us about 3 months to produce all the pipes API 650 flat-bottom steel tanks . We use bulk vessel to ship the pipe to Karachi port. Our engineers went to Karachi port to inspect the condition along with the customer when ship arrive. The customer gave high appraise to the pipe quality and our service

Requirements for prefabrication of the top of large vertical API 650 flat-bottom steel tanks: The prefabrication of the tank top shall be prefabricated in blocks according to the drawings. Pay attention to the spacing of the welds after installation when setting out the material. Reinforcing ribs should be formed and inspected with an arc-shaped template. When a single top plate needs to be spliced, butt joints should be used. The forming of a single top plate should be welded between the reinforcing ribs and the top plate on the mould. After forming, check with an arc-shaped sample plate, and the gap should not be greater than 10 mm.

Respect customers and treat each other sincerely. Customers are always right. Always remember that the user is the God of the enterprise, respect the customer, and accept the customer's opinion modestly is the guarantee of the long-term development of the enterprise. Adhere to this concept, so that the service and the product are the same, long-term.