6063 aluminum rod API Std 650 SUG III tanks

API 650 petroleum storage tank stipulates that if the thickness of the lower siding obtained by calculating the anti-overturning moment is greater than the thickness of the API Std 650 SUG III tanks hydrostatic pressure test (both do not include the corrosion margin), the calculated thickness of the above siding required by the hydrostatic pressure is It should also be increased by the same proportion, unless special analysis is performed to determine the seismic overturning moment and corresponding stress at the bottom of each layer of API 650 petroleum storage tank wall.

In this project, an elemental area of tank wall used is constructed of ASTM A442 Grade 55 steel plate subjected to a meridional unit force, T1, of 4000 lbf/in.2 tension and a latitudinal unit force, T2, of 5060 lbf/in.2 compression. The meridional radius of curvature, R1, is 75 in., and the length of the normal from the surface to the axis of revolution, R2, is 300 in. The joints in the wall are of double-welded butt-joint construction with a tensile efficiency of 85%. A corrosion allowance of 1/16 in. is required.
The problem in this example is to graphically find the minimum thickness of tank wall required for the given conditions (see 5.10.3.3).
Solution: As determined from Table 5-1, the maximum allowable tensile stress value, Sts, for ASTM A442 Grade 55 steel plate in simple tension is 16,500 lbf/in.2. Since the compressive stress is latitudinal, the governing value of R in this situation is R1, or 75 in.

When the API Std 650 SUG III tanks is welded, the weldment should be fixed rigidly. After welding, when the weldment is cooled to normal temperature, the rigid fixation can be removed, which can effectively prevent angular deformation and wave deformation. Although some measures have been taken, the welding deformation of API Std 650 SUG III tanks is still unavoidable, so it is necessary to take corrective measures to compensate the deformation. Mechanical correction is to make the parts easy to deform in the welding process by mechanical or other rigid materials to produce simple deformation, so as to restore the state before welding.

Strengthen system construction. The system itself has a certain binding force, which specifies the rights and obligations of employees. It is a passive management means for employees. Its purpose is to promote each employee to develop good professional habits, form good behavior norms, and promote the improvement of enterprise management level.

In the process of API Std 650 SUG III tanks steel transportation, enterprises often use railway transportation, highway transportation, water transportation and other ways to transport. According to the cargo owner's requirements on the timeliness of the goods and the different transportation routes, our company will choose API Std 650 SUG III tanks different modes of transportation. According to the specific needs of customers, or specify the mode of transportation.

To provide customers with the most satisfactory service and realize the win-win of economic and social benefits, our company promises to provide excellent API Std 650 SUG III tanks products in this bidding, and in line with the attitude of being serious and responsible to customers, before sending goods to users, the API Std 650 SUG III tanks technical personnel shall confirm that there is no fault in the equipment before sending goods to users, and then send goods and products to users, and formulate the following service terms.