EN 10025 S355 plates API 650 stainless and carbon steel tank

Density of API 650 stainless and carbon steel tank Liquid Stored
The density of the liquid stored shall be its maximum density within the range of design temperatures, but no less than 29.3 lbf/ft3 for methane, 34.21 lbf/ft3 for ethane, and 35.5 lbf/ft3 for ethylene.
Design Metal Temperature
The design metal temperature of each component exposed to the liquid or vapor being stored shall be the lower of the temperatures specified as follows: The design metal temperature of the components of the API 620 single-wall tank or the inner tank of a double-wall tank shall be the minimum temperature to which the tank contents shall be refrigerated, including the effect of subcolony at reduced pressure."

Under the same sealing effect, the internal floating roof tank of API 650 oil storage tank can further reduce the evaporation loss compared with the API 650 stainless and carbon steel tank External floating roof tank. This is due to the shielding of the fixed roof and the gas layer between the fixed roof and the internal floating plate, which has more significant heat insulation effect than the double disc floating roof of the API 650 stainless and carbon steel tank external floating roof tank.

Prefabrication requirements of API 650 stainless and carbon steel tank, large vertical storage tank wall panels:
1. The prefabrication of wall panel shall be processed in strict accordance with the requirements of the drawings, and inspection records shall be made.
2. After the wall panel is rolled, it should be placed on the platform for inspection with a template. In the vertical direction, use a straight-line template to check, the gap should not be greater than 2 mm, and in the horizontal direction, use an arc-shaped template to check, and the interval should not be greater than 4 mm.
3. When wall panels are rounded, attention should be paid to prevent irreversible plastic deformation caused by external forces. After rolling, it should be placed on the platform for inspection, and then placed on the prepared mold.