Closed- and open top API standard 650 insulated tanks

Preheat Treatment
Many laboratory tests have shown preheat treatment of carbon steel to 300°F-400°F to be the equivalent of the post-heat treatment at no less than 1100°F insofar as the physical properties of the weldment are concerned.40,41 Some tests have indicated a slight advantage of the post-heat treatment. Most of the tests have been made on plates 3/4 in. - 1 in. thick; results must be viewed with caution if preheating is applied appreciably beyond this thickness range. However, for all practical purposes, improvement resulting from preheating is sufficiently well established so that preheat should be considered for field fabrication of API 620 crude oil tank plates over 3/4-in. thick whenever toughness of the tank API standard 650 insulated tanks is highly desired and the thermal post-heat treatment is impractical.

The characteristics of the API standard 650 insulated tanks internal floating roof structure of API 650 petroleum storage tanks: the inner floating roof or inner floating plate refers to the floating roof that floats on the liquid surface of the oil tank with the oil and liquid up and down. The API standard 650 insulated tanks inner floating roof is used to cover the liquid. The surface is currently recognized as the most ideal and most economical and practical way to reduce oil evaporation loss.

The Seamless Pipe Q345D to Thailand. In November of 2015, Thailand OTTO group contacted with us from Internet. They are finding the trustable supplier of S355/2H seamless pipe for the cable car supporter. Due to the special using of the pipes, they are very careful and serious when choosing the supplier. After one months contact and discussion by email, they come to our company. We drive to the pipe mill for visit of 2 days. Through this visit, they are very confident with our production ability and products quality. Finally, they accept the grade we suggest Q345D. After back to office, they put the order of 1800 tons pipe to us directly.

The structure of the API standard 650 insulated tanks foundation mainly includes the insulating anticorrosion layer on the top surface of the foundation, the tank wall support, the edge retaining structure, the sand cushion, the oil and water barrier, the detection signal tube and other structures. The construction materials and requirements of each basic structure of the storage tank are different. After the structure of the API standard 650 insulated tanks foundation is built in accordance with the construction requirements, the settlement of the storage tank foundation needs to be observed, and the uneven settlement value of the storage tank foundation should be within the allowable safety range.

We should help solve the customer's problems in time, not just verbally, without solving the problems or shirking the responsibility. Improving after-sales efficiency can make customers feel respect. We should take their problems seriously and show sincerity. It can also give customers a good impression and reduce the negative impact.