ASTM A992 structural shapes API 650 mechanically-anchored tanks

Prefabrication requirements of API 650 mechanically-anchored tanks, large vertical storage tank wall panels:
1. The prefabrication of wall panel shall be processed in strict accordance with the requirements of the drawings, and inspection records shall be made.
2. After the wall panel is rolled, it should be placed on the platform for inspection with a template. In the vertical direction, use a straight-line template to check, the gap should not be greater than 2 mm, and in the horizontal direction, use an arc-shaped template to check, and the interval should not be greater than 4 mm.
3. When wall panels are rounded, attention should be paid to prevent irreversible plastic deformation caused by external forces. After rolling, it should be placed on the platform for inspection, and then placed on the prepared mold.

Low-pressure Storage Tanks Fireproofing
Although general fire prevention and fire protection measures are expected to be fully covered by other safety codes, tanks API 650 mechanically-anchored tanks constructed according to these rules, which may be subject to fire exposure resulting from any cause, shall have their supports suitably fireproofed.
Special consideration shall be given to provisions for ample drainage facilities for accidental spills or leakage of flammable contents from such tanks or adjacent piping and other equipment if the contents may become ignited.
Subject to special considerations in isolated locations, tanks in which flammable liquid products are stored at temperatures well above their average boiling point shall be suitably fireproofed or otherwise protected.

API 650 is an American standard for welding flat bottom vertical storage tanks. This API 650 mechanically-anchored tanks standard specifies requirements for the design, manufacturing, welding, inspection and installation of storage tanks. API 650 is widely used in storage tanks designed to withstand low internal pressures and used to store typical products such as API 650 mechanically-anchored tanks crude oil, gasoline, chemicals and water. BBN has extensive experience in API 650 tanks, from +/- 500 cubic meters of tanks produced in the factory to +/- 15000 cubic meters of tanks produced on site.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!