API 650 self anchored flatbottom tanks with heavy shells

We can process the steel materials according to your drawing. Or if you can not make drawing, please send us API 650 self anchored flatbottom tanks specific data and requirements, our technical department can make design and drawing for you, and then confirm with your technician or engineer. If all is OK, our processing center will process the steel materials according to the drawing. So no matter what size and shapes you need, we can meet demands at the most time.Ultrasonic Examination of Butt-welds in Plates
Butt-welds in all tank wall courses subjected to a maximum actual operating membrane tensile stress, perpendicular to the welded joint, greater than 0.1 times the specified minimum tensile strength of the API 650 self anchored flatbottom tanks plate material shall be completely examined.
Butt-welds in API 620 oil tank wall courses subjected to maximum actual operating membrane tensile stress, perpendicular to the welded joint, less than or equal to 0.1 times the specified minimum tensile strength of plate material shall be spot examined in accordance with Figure Q-2.The interior of API 650 storage tanks to be internally lined or coated must have all edges rounded to a minimum of 3 mm radius. Internal welds must be completely seal welded, ground smooth, and free from API 650 self anchored flatbottom tanks surface porosity, pockets, and high spots. Remove weld spatter. Vendor as specified on API 650 storage tanks drawing must perform additional surface preparation.Enterprise style: unity, pragmatism, responsibility, and endeavorOperation Policy: realistic management, innovative technology, high quality, fast efficiency, low cost and complete service. Enterprise spirit: every year, every day, we should make progressEnterprise development is a process of continuous pursuit of progress. This spirit is reflected in the whole three-dimensional space of every person, every event and every time point in our enterprise. We should always continue to explore, break through and improve.Prefabrication requirements for API 650 self anchored flatbottom tanks, large vertical storage tanks:
1. The machined surface of the edge of the steel plate should be smooth, and there should be no defects such as slag inclusion, delamination, cracks, etc., and the surface hardened layer produced by the flame cutting groove should be removed.
2. Dimension deviation after steel plate processing: the deviation of plate width is less than 1.5 mm, the deviation of plate length is less than 2 mm, and the difference between diagonals is less than 3 mm.