5154 aluminum bar API Std 650 anchored tanks

When the API Std 650 anchored tanks top shell course is the minimum thickness indicated in 5.10.4, Table 5-6 and Figure 5-6, details a – e, h and i, the minimum anchorage shall be designed for normal loads as specified by the Purchaser and by this standard. See 5.11.2.3 for the allowable stress. When the top shell course is thickened beyond the minimum thickness provided in Table 5-6 or as in Figure 5-6, details f and g, or a knuckle is used, the minimum anchorage shall be designed for three times the internal design pressure. The allowable stress for this loading is 90% of the minimum specified yield strength of anchorage material.For API 650 tanks Projection from outside of tank shell to extreme face of flange - plus or minus 5 mm. API Std 650 anchored tanks Elevation or radial location - plus or minus 6 mm. API 650 tanks Flange tilt in any plane, measured on the diameter across the gasket surface - plus or minus degree but not exceeding 5 mm. Flange bolt hole orientation - plus or minus 2 mm.In 2013, one of our clients in Korea purchased 890 tons Q345B square tube from us for one building construction project. Our clients required no burr in the side of the tube, we finally produce the goods with great condition and +/-0.25mm tolerance for wall thickness, which is a very great tolerance with customers’ required size. Our square tube full available range is 2-16mm for wall thickness, and 40-500mm for width. In addition, our Q/C department will seriously control all of the process of every order.Proper use of API Std 650 anchored tanks and precautions:
1. The API Std 650 anchored tanks must be used within the safe height range;
2. Check before use to ensure that the safety valve and breathing valve are flexible and easy to use;
3. The explosion-proof and fire-proof safety measures for oil tanks are implemented effectively;
4. The oil level in the API Std 650 anchored tanks should be accurately measured when receiving and delivering oil, so as to prevent overflow or empty;
5. In the process of receiving and sending oil, the flow rate of oil should be controlled, and it should not be too fast to avoid electrostatic accidents.The after-sales service department will pay return visit to each customer by call or email, report problems found during the return visit in time, and discuss with the production and quality inspection center to propose effective solutions and follow up in a timely manner, so as to ensure the benefits each customer are fully guaranteed, and to provide customers with more value-added services.