The bottom of API Std 650 welded aluminum storage tanks

For all API 620 crude oil tank other materials, the impact test temperature shall be at least 30°F colder than the design metal temperature. Alternately, materials impact tested at the design metal temperature or lower with Charpy impact test energy value of 25 ft-lb (average), 20 ft-lb (minimum) are acceptable for design metal temperatures above –40°F. API Std 650 welded aluminum storage tanks materials with an energy value of 30 ft-lb (average), 25 ft-lb (minimum) are acceptable for design metal temperatures of –40°F or lower.

The effect of air pressure on the API Std 650 welded aluminum storage tanks tank walls of the API 650 tank must be considered when the design pressure is greater than 2 kPa.The fixed point method can be used to design the tank wall of atmospheric or micro internal pressure API Std 650 welded aluminum storage tanks storage tank.

In October, 2018, our Malaysia customer purchased 600 Tons CCS-AH36 Ship Building Steel Plates to use in their shipbuilding project .This customer is a famous shipyard in Malaysia. Their company has the business scope of tourism, API Std 650 welded aluminum storage tanks shipbuilding, transportation and so on. As a terminal manufacturer, they have strict requirements on quality . After visiting our factory, the customer are very satisfied with the quality of this batch of API Std 650 welded aluminum storage tanks CCS-AH36 Ship Building Steel Plates.

Proper use of API Std 650 welded aluminum storage tanks and precautions:
1. The API Std 650 welded aluminum storage tanks must be used within the safe height range;
2. Check before use to ensure that the safety valve and breathing valve are flexible and easy to use;
3. The explosion-proof and fire-proof safety measures for oil tanks are implemented effectively;
4. The oil level in the API Std 650 welded aluminum storage tanks should be accurately measured when receiving and delivering oil, so as to prevent overflow or empty;
5. In the process of receiving and sending oil, the flow rate of oil should be controlled, and it should not be too fast to avoid electrostatic accidents.

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.