EN 10025 S355 plates API 650 SUG I tanks
Low-pressure storage tanks FireproofingAlthough general fire prevention and fire protection measures are expected to be fully covered by other safety codes, tanks API 650 SUG I tanks constructed according to these rules, which may be subject to fire exposure resulting from any cause, shall have their supports suitably fireproofed.Special consideration shall be given to provisions for ample drainage facilities for accidental spills or leakage of flammable contents from such tanks or adjacent piping and other equipment if the contents may become ignited.Subject to special considerations in isolated locations, tanks in which flammable liquid products are stored at temperatures well above their average boiling point shall be suitably fireproofed or otherwise protected.API 650 petroleum storage tank has the advantages of high safety: the API 650 SUG I tanksinner floating plate floats on the liquid surface, so that the liquid phase has no evaporation space, which can reduce the evaporation loss by 85% to 90%. At the same time, the API 650 petroleum storage tank blocks the air and liquid storage through the floating disk, which reduces air pollution and reduces the degree of fire risk.In 2014, we offered 175 ton Cold rolled stainless steel plate to Thailand. The API 650 SUG I tanks products are from TISCO. Here is the MTC that we offered to customer. We have our own quality team. Our quality team will inspect every order before shipment for customer. Normally, we will test the chemical composition, thickness, width, and length. Here are some pictures for last inspection.Before welding the API 650 SUG I tanks, the professional skills of the welding personnel shall be fully assessed to ensure that the operators meet the corresponding welding qualifications. According to the technical standards, scientific and feasible process requirements are actually formulated. In the process of welding the edge plate of API 650 SUG I tanks, electric welding is required on one side of the edge plate, so that the edge plate has a free shrinkage effect and greatly reduces the residual stress of the welding seam.Due to other non-steel quality reasons caused by the customer dissatisfaction, to timely explain to the customer, and help them solve the problem, for the customer really because of their own reasons, to give patient reply.The process of objection handling is the process of our technical service.
Latest NewsMore+