API Std 650 flat-bottom tanks primary seal

Proof Tests for Establishing Allowable Working PressuresBecause pressures in liquid storage tanks built according to these rules vary quite markedly from the tops to the bottoms of the tanks, proof testing of these tanks presents problems not usually encountered in the construction of unfired pressure vessels–especially where the API Std 650 flat-bottom tanks parts under investigation are located near the bottoms of the tanks. The principal difficulty is devising a test or series of tests that will reliably establish the working pressure that can be permitted on the part of the unproven design without, at the same time, imposing hazardous conditions on other parts located at higher levels in the tank.

API 650 storage tank is used for commonly used oil, gasoline, diesel, chemical and production water storage. API Std 650 flat-bottom tanks Storage tanks built to these standards are spread across U.S. refineries, terminals, pipelines, and production facilities. The API 650 detailed standard specifies the design, processing, welding, inspection and installation procedures for storage tanks.

Our client purchase more than 900 tons pipe API Std 650 flat-bottom tanks from India. And we do the inspection for each one pipe before shipment.During the inspection, the inspector saw that the surface of the square pipe kept the original color of the stainless steel, no fracture, no depression and other quality defects was found.

The preparatory work before the construction of the API Std 650 flat-bottom tanks is an important part of the oil tank project. Material purchase preparation before the construction of the API Std 650 flat-bottom tanks:
Before API Std 650 flat-bottom tanks construction, all materials shall be purchased and prepared, and the specifications and quality of materials shall be inspected to see if they meet the construction operation requirements. Fire and rain proof measures should be taken when storing materials. Paint should be stored in a ventilated and dry place.

Due to other non-steel quality reasons caused by the customer dissatisfaction, to timely explain to the customer, and help them solve the problem, for the customer really because of their own reasons, to give patient reply.The process of objection handling is the process of our technical service.