API 650 partially anchored liquid-storage tanks ladders
In addition to the requirements of API Standard 620 tank Appendix Q.8.1, the nameplate shall be attached to the tank at an accessible location if it is outside of any insulation or protective covering of the tank. The nameplate for the inner tank shall be located on the outer tank wall but shall refer to the inner tank. The nameplate, if any, for the outer tank of a double-wall tank shall be located adjacent to the nameplate or the inner tank and shall refer to the outer tank.
This standard applies only to API 650 tank API 650 partially anchored liquid-storage tanks whose entire bottom is uniformly supported and to API 650 tank in non-refrigerated service that have a maximum design temperature of 93°C (200 °F) or less.
In 2014, we offered 175 ton Cold rolled stainless steel plate to Thailand. The API 650 partially anchored liquid-storage tanks products are from TISCO. Here is the MTC that we offered to customer. We have our own quality team. Our quality team will inspect every order before shipment for customer. Normally, we will test the chemical composition, thickness, width, and length. Here are some pictures for last inspection.
}The cone slope of the completed API 650 partially anchored liquid-storage tanks foundation is 15/1000 for the general foundation and less than 35/1000 for the soft foundation. After the foundation settlement of the storage tank is basically stable, the surface slope must be greater than eight thousandths. The edge of the tank bottom should be more than 0.3 meters higher than the surrounding ground. Above the ground, the tank bottom leakage detection tube should be drawn from the foundation sand cushion and cross the foundation ring wall or the slope protection surface. The circumferential distance should be less than 20 meters, and each API 650 partially anchored liquid-storage tanks should have at least 4 detection tubes.
After-sales service is an important part of measuring a product good or not. After sales service can't be ignored. Good service can really make consumers feel relieved. We have always done a good job in after-sales service, so as to bring consumers a better reference when purchasing and a better experience during use of our steel materials. We will call back and follow up the performance of our steel products regularly.
