A573 grade 70 plates API standard 650 open-top tanks

The API standard 650 open-top tanks stiffener ring and backing strip (if used) are primary components, and they shall comply with the requirements of API 620 storage steel tank Q.2.1. The stiffener rings may be fabricated from plate using an intermittent weld on alternating sides between the web and the flange.
Except for aluminum or stainless steel tanks, all fillet welds shall consist of a minimum of two passes. The ends of the fillet welds shall be 2 in. from the rat hole (see Figure Q-1), and these welds shall be deposited by starting 2 in. from the rat hole and welding away from the rat hole. An acceptable alternative to the detail that includes stopping fillet welds 2 in. short of the rat hole would be to weld continuously through the rat hole from one side of the stiffener to the opposite side. All craters in fillet welds shall be repaired by back welding.

API 650 internal floating roof oil tank executive standard: domestic design standard: GB50341-2003 "Vertical cylindrical steel welded oil tank design code"; domestic construction standard: GB50128-2005 "vertical cylindrical steel welded oil tank" Construction and Acceptance Specification; API standard 650 open-top tanks Foreign design standard: API650-2007 "Standard for Welded Steel Petroleum storage tanks."

We cooperated with the Peruvian government for many years. And supply them large diameter steel pipes and pipe fittings to support their Hydropower Station Projects. We do 100% UT, RT, Hydraulic test and so on tests for the API standard 650 open-top tanks steel pipes. And do PT, MT and so on tests for the pipe fittings. We published "Welding Procedure Qualification report" after production. And our mill will keep the test record in the documentary department for 5 years. If meet any problems in following application, we can check the test record easily and assist to solve problems at the first time.

In the actual welding of API standard 650 open-top tanks, operators will use more arc-shaped plates for tailor-welding to better adapt to the larger volume of oil storage tanks. In order to effectively control the deformation of the welding seam of the API standard 650 open-top tanks, a scientific and accurate prefabricated bottom plate is required. In the process of prefabricating the bottom plate of the oil storage tank, it is necessary to strictly follow the technical requirements for the construction of the oil storage tank. At the same time, it is also necessary to clarify the external dimensions according to its actual manufacturing standards so that it has sufficient shrinkage.

There is a careful, patient, enthusiastic and thoughtful after-sales team, a professional distribution, ultra-efficient warehouse and logistics center, a marketing team with marketing expertise, an innovative technology center with strong steel technology, an experienced manufacturing center with rigorous professionalism Quality Inspection Center, an operation team with many years of administrative management experience. Such a strong combination of teams makes BEBON a steel giant in Henan Province.