Materials used in the construction of API Std 650 low-alloy steel tanks

The floating roof is the top cover floating on the liquid level, so the sealing performance of API Std 650 low-alloy steel tanks API 650 oil storage tank is very important. The floating plate mainly adopts elastic packing, and at the same time, it is compressed with the wall of API 650 oil storage tank with pressure strip around, and fixed with the floating plate with bolts. After the API Std 650 low-alloy steel tanks floating plate is lowered to a certain position of about 1.8m, a prop will support the floating plate to keep it in position.

Crack treatment of API Std 650 low-alloy steel tanks weld area: find out the crack tip with ray or ultrasonic flaw detection, drill cut-off holes at both ends of the crack with the cut-off method, the hole depth is slightly greater than the crack depth, or groove (crack stop groove) is made by angle grinder at both ends of the crack, shovel and grind the whole crack, and grind it into a suitable groove; use radiographic inspection and dye detection to verify that the crack has been completely excavated, and finally repair welding.

API 620 Steel Oil Tank Bottom and Shell Support
The tank API Std 650 low-alloy steel tanks under-bottom insulation shall be designed to resist the combined pressures from the product load, the overturning seismic load and the vertical seismic load. These seismic pressures may be combined by SRSS.
The bearing ring under the shell shall be designed to resist the calculated OLE peak compressive force in the tank shell due to overturning (see API 650 oil tank, Section E.6.2.2), including dead and live loads. A 33 % increase in allowable bearing stress is permitted.

The quality inspection department is responsible for the inspection management of raw materials and finished products, and the quality inspection and acceptance of products and raw materials. Strictly abide by the company's management system, conscientiously exercise the management power given by the company, and put an end to all ultra vires; be responsible for the inspection of all kinds of raw materials entering the company, and put forward quality problems and handling opinions.

Iron and steel goods, including pig iron, ingots, all kinds of steel and so on. Therefore, logistics companies are required to load evenly and evenly in the process of transportation, prevent moisture and prevent corrosion. It is necessary to prevent the API Std 650 low-alloy steel tanks steel sheet from being mixed with water when transporting the steel; it is necessary to prevent the API Std 650 low-alloy steel tanks steel from being mixed with water when transporting the steel; it is necessary to prevent the steel from being mixed with water when transporting the steel; it is necessary to prevent the steel from being mixed with water when transporting the steel; it is necessary to prevent the steel from being mixed with water when loading the API Std 650 low-alloy steel tanks steel sheet on the truck Good luck.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!