ISO 630 Gr E355 plates API Std 650 floating-roof tanks

For API 650 tanks Projection from outside of tank shell to extreme face of flange - plus or minus 5 mm. API Std 650 floating-roof tanks Elevation or radial location - plus or minus 6 mm. API 650 tanks Flange tilt in any plane, measured on the diameter across the gasket surface - plus or minus degree but not exceeding 5 mm. Flange bolt hole orientation - plus or minus 2 mm.

The inner and outer tanks may be decoupled for seismic design of the tank and anchorage and assumed to act independently. However, if the inner and outer tanks API Std 650 floating-roof tanks are supported by a common foundation, the seismic foundation loading shall be calculated using the lesser response modification values for either the inner tank or outer tank for both tanks and a dynamic analysis shall be performed to determine the combined effect.
Allowable Stresses: For Appendix R tanks, design allowable stresses shall be per API 620 large low pressure storage tank, Section R.3.3.

Prefabrication requirements for API Std 650 floating-roof tanks, large vertical storage tanks:
1. The machined surface of the edge of the steel plate should be smooth, and there should be no defects such as slag inclusion, delamination, cracks, etc., and the surface hardened layer produced by the flame cutting groove should be removed.
2. Dimension deviation after steel plate processing: the deviation of plate width is less than 1.5 mm, the deviation of plate length is less than 2 mm, and the difference between diagonals is less than 3 mm.

Do a good job of thought introduction based on people. Human based management is the most important link in standardizing employee behavior management. In daily behavior management, we should establish the central position of human and play an important role of human. Employees are not only the builders and exercisers of corporate culture, but also the executors of code of conduct. The code of conduct should be finally implemented into the thoughts and actions of employees.

Ningbo port has trade and transportation with more than 50 countries and regions, such as the United States, CIS countries, Europe, Africa, Japan and South Korea, Southeast Asia, the Middle East and Hong Kong. Ningbo port has initially formed an all-round three-dimensional collection and distribution network of expressways, railways, aviation, river sea intermodal transport, water to water transfer, etc.

The after-sales service department will pay return visit to each customer by call or email, report problems found during the return visit in time, and discuss with the production and quality inspection center to propose effective solutions and follow up in a timely manner, so as to ensure the benefits each customer are fully guaranteed, and to provide customers with more value-added services.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!