CSA G40.21 grade 38WT plates API 650 liquid-storage tanks

The process parameters should be strictly controlled in sand blasting of API 650 liquid-storage tanks. The working pressure of abrasive chamber is between 0.5 and 0.6a, and the outlet pressure of air compressor shall not be lower than 0.6 WPa. According to the test results, the distance between nozzle and workpiece shall be controlled at 80 - 200 mm and spraying angle of 30 ~ 75°is appropriate.

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.

When the API 650 liquid-storage tanks top shell course is the minimum thickness indicated in 5.10.4, Table 5-6 and Figure 5-6, details a – e, h and i, the minimum anchorage shall be designed for normal loads as specified by the Purchaser and by this standard. See 5.11.2.3 for the allowable stress. When the top shell course is thickened beyond the minimum thickness provided in Table 5-6 or as in Figure 5-6, details f and g, or a knuckle is used, the minimum anchorage shall be designed for three times the internal design pressure. The allowable stress for this loading is 90% of the minimum specified yield strength of anchorage material.

Standard API 650 tank calls for calculations based on the specific gravity of the liquid product being stored. This permits the thickness of the steel API 650 liquid-storage tanks needed as well as other specifications of how the tank is built to be determined by the weight of the API 650 tank.