API Std 650 tanks primary seals

During the use of API Std 650 tanks, the tank material is prone to crack and leakage under the action of pressure, corrosion, wear and other conditions. Especially in the oil producing area, the temperature difference in four seasons is large and the natural environment is bad, which will accelerate the consumption of oil storage tank and cause many potential safety hazards. Therefore, the API Std 650 tanks must undergo strict inspections before being put into use after the production and installation are completed, so as to avoid cracks and leakage in short-term use and affect production safety.

The {keyword shell that contains the liquid shall have butt-welded annular bottom plates with a radial width that provides at least 24 in. between the inside of the shell and any lap-welded joint in the remainder of the bottom and at least a 2-in. projection outside the shell. The stated values apply to full-sized specimens. For sub-size specimen acceptance criteria, see ASTM A20. An impact test temperature lower than the design metal temperature may be used by the API 620 large welded, low pressure storage tanks Manufacturer.

Prevent the storage liquid from impacting the inner wall of the API 650 petroleum storage tank or increase the internal pressure, reduce the corrosion of the tank top and the tank wall, and extend the service life of the API Std 650 tanks storage tank.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!