API Std 650 mechanically-anchored flat-bottom tanks shell attachments and tank appurtenances

Suggested Practice Regarding Installation of Low-pressure storage tanks
Access: All openings and accessories for tanks API Std 650 mechanically-anchored flat-bottom tanks constructed according to this standard shall be installed so that any periodic inspections required can be readily made.
Corrosion: When a tank bottom rests directly on the ground, a survey shall be made to establish the need for cathodic protection.
Drainage: All tanks in which water might accumulate under the hydrocarbon contents shall be provided with adequate drains that are suitably protected from freezing.

Test welds of each API 650 tank nozzle and manway reinforcing pad (or each section of multiple piece pad) using dry air and apply a soap solution test in the presence of Purchaser's Inspector before hydro testing the API Std 650 mechanically-anchored flat-bottom tanks tank. Tap one inch NPT test hole in each pad or section.

In December of 2015, our regular India customer sent us an inquiry for API Std 650 mechanically-anchored flat-bottom tanks pipe. The inquiry requires no negative tolerance in both pipes’ outer diameter and pipe wall. After two weeks’ discussion, he put the order of 275 tons to us. The pipes are finished within just one month. Our customer come to our factory to inspect the quality and tolerance, all the products are well meet his demand. The pipes are arriving to Nhava Sheva port, customer is very happy with our products and service during the process.

Welders participating in the construction of API Std 650 mechanically-anchored flat-bottom tanks must pass the examination and perform welding within the validity period of the qualified items. Special operators such as on-site maintenance electricians, cranes, and shelf workers must hold job certificates. All oil pipelines need to use arc welding for bottoming and electric welding to ensure the welding quality. Oil tanks and process pipelines must be tested for non-destructive flaws in accordance with the flaw detection ratios and methods required by the design and acceptance specifications. The flaw detectors must be certified.

The after-sales service personnel understand the user's ideas and needs in detail, and stand on the other side's position and interests. Actively communicate with users and help them solve practical problems. This not only solves the service problem, but also improves the customer's trust in the company.