API Std 650 larger diameter tanks full-face gasket

The quality inspection department is responsible for the inspection management of raw materials and finished products, and the quality inspection and acceptance of products and raw materials. Strictly abide by the company's management system, conscientiously exercise the management power given by the company, and put an end to all ultra vires; be responsible for the inspection of all kinds of raw materials entering the company, and put forward quality problems and handling opinions.

When the API Std 650 larger diameter tanks is welded, the weldment should be fixed rigidly. After welding, when the weldment is cooled to normal temperature, the rigid fixation can be removed, which can effectively prevent angular deformation and wave deformation. Although some measures have been taken, the welding deformation of API Std 650 larger diameter tanks is still unavoidable, so it is necessary to take corrective measures to compensate the deformation. Mechanical correction is to make the parts easy to deform in the welding process by mechanical or other rigid materials to produce simple deformation, so as to restore the state before welding.

Ultrasonic Examination of Butt-welds in Plates
Butt-welds in all tank wall courses subjected to a maximum actual operating membrane tensile stress, perpendicular to the welded joint, greater than 0.1 times the specified minimum tensile strength of the API Std 650 larger diameter tanks plate material shall be completely examined.
Butt-welds in API 620 oil tank wall courses subjected to maximum actual operating membrane tensile stress, perpendicular to the welded joint, less than or equal to 0.1 times the specified minimum tensile strength of plate material shall be spot examined in accordance with Figure Q-2.