API Std 650 flexible liquid storage tanks nominal thickness

The finned tube heating device for high temperature heat transfer oil for large API Std 650 flexible liquid storage tanks has the advantages of convenient inspection and maintenance. The high-efficiency fin heating coil assembly is composed of spirally arranged finned coils. The fins are mainly arranged in the straight pipe section, and the whole assembly is supported by several angle steel supports. The high-efficiency fin heating coil component can enter and exit from the manhole of the API Std 650 flexible liquid storage tanks, which is convenient for maintenance and repair.

Over the years, the company has strived for perfection, being well-received. By virtue of stable product performance, high-quality engineering effects and perfect service system, we have won the trust of many customers, and our engineering cases and after-sales service systems are spread all over the world. We regularly conduct quality tracking and return visits by phone and email, listen to customers' opinions, and continuously improve service quality.

Storage Tank Annular Bottom Plates
Thickness shall be per API 650, Appendix E (with loads modified by requirements of this appendix) plus corrosion allowance unless a thickness increase is required for compliance with Appendix R or Appendix Q. Annular plate width shall be per API 650, Appendix E (with loads modified by requirements of this appendix) unless a width increase is required for compliance with Appendix R or Appendix Q. Thickness used for determination of API 650 welded storage tank standard, Appendix E width shall be based on the thickness required for seismic product hold down.

For API 650 tanks Projection from outside of tank shell to extreme face of flange - plus or minus 5 mm. API Std 650 flexible liquid storage tanks Elevation or radial location - plus or minus 6 mm. API 650 tanks Flange tilt in any plane, measured on the diameter across the gasket surface - plus or minus degree but not exceeding 5 mm. Flange bolt hole orientation - plus or minus 2 mm.