API standard 650 stainless and carbon steel tank dead load

API 650 petroleum storage tank stipulates that if the thickness of the lower siding obtained by calculating the anti-overturning moment is greater than the thickness of the API standard 650 stainless and carbon steel tank hydrostatic pressure test (both do not include the corrosion margin), the calculated thickness of the above siding required by the hydrostatic pressure is It should also be increased by the same proportion, unless special analysis is performed to determine the seismic overturning moment and corresponding stress at the bottom of each layer of API 650 petroleum storage tank wall.

In addition to quality assurance, service is also important for the competition of steel suppliers. All the after-sales service personnel of the company have received professional training and assessment. The steel products supplied by our company enjoy the life-long quality problem replacement service. In the process of using our steel API standard 650 stainless and carbon steel tank products, if there is any problem, just contact us in time, and our after-sales service personnel will look for countermeasures and solve the problem with you as soon as possible.

Proof Tests for Establishing Allowable Working PressuresBecause pressures in liquid storage tanks built according to these rules vary quite markedly from the tops to the bottoms of the tanks, proof testing of these tanks presents problems not usually encountered in the construction of unfired pressure vessels–especially where the API standard 650 stainless and carbon steel tank parts under investigation are located near the bottoms of the tanks. The principal difficulty is devising a test or series of tests that will reliably establish the working pressure that can be permitted on the part of the unproven design without, at the same time, imposing hazardous conditions on other parts located at higher levels in the tank.

Our company will set up a full-time service engineer for the project, who is responsible for the interface and coordination of technical support and after-sales service of the API standard 650 stainless and carbon steel tank project. In response process of customer service center, in case of technical support and after-sales service demand, the user shall contact the full-time engineer of API standard 650 stainless and carbon steel tank customer service center, and the technical personnel will give corresponding answers and on-site treatment according to the needs of users.