API standard 650 self-anchored tanks internal floating roof loads

During the use of API standard 650 self-anchored tanks, the tank material is prone to crack and leakage under the action of pressure, corrosion, wear and other conditions. Especially in the oil producing area, the temperature difference in four seasons is large and the natural environment is bad, which will accelerate the consumption of oil storage tank and cause many potential safety hazards. Therefore, the API standard 650 self-anchored tanks must undergo strict inspections before being put into use after the production and installation are completed, so as to avoid cracks and leakage in short-term use and affect production safety.

Under the same sealing effect, the internal floating roof tank of API 650 oil storage tank can further reduce the evaporation loss compared with the API standard 650 self-anchored tanks External floating roof tank. This is due to the shielding of the fixed roof and the gas layer between the fixed roof and the internal floating plate, which has more significant heat insulation effect than the double disc floating roof of the API standard 650 self-anchored tanks external floating roof tank. =====
API 650 tank has the advantages of less load on the floating plate, simple and light structure, and can save the central drainage pipe and rotating floating ladder on the API standard 650 self-anchored tanks floating plate. The materials for easy construction and maintenance and sealing parts can avoid aging due to sunlight.

The company uses outsourced logistics operations. Our cooperated professional third-party logistics providers use the advantages of large-scale production and cost advantages to achieve cost savings by increasing the utilization of resources in each link, so that we can benefit from the separation of cost structure. Therefore, we can also provide customers with better, faster and more efficient cargo transportation, delivery, and lower freight costs.

Preheat Treatment
Many laboratory tests have shown preheat treatment of carbon steel to 300°F-400°F to be the equivalent of the post-heat treatment at no less than 1100°F insofar as the physical properties of the weldment are concerned.40,41 Some tests have indicated a slight advantage of the post-heat treatment. Most of the tests have been made on plates 3/4 in. - 1 in. thick; results must be viewed with caution if preheating is applied appreciably beyond this thickness range. However, for all practical purposes, improvement resulting from preheating is sufficiently well established so that preheat should be considered for field fabrication of API 620 crude oil tank plates over 3/4-in. thick whenever toughness of the tank API standard 650 self-anchored tanks is highly desired and the thermal post-heat treatment is impractical.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!