API standard 650 self-anchored tank national standards plates

Requirements for prefabrication of bottom plate of large vertical API standard 650 self-anchored tank:
1. The diameter of tank bottom should be enlarged by 0.1% ~ 0.15% according to the design diameter.
2. The minimum dimension of edge plate along the radius direction of tank bottom shall not be less than 700mm.
3. The distance between any adjacent welds of the base plate shall not be less than 300 mm.

Pressure Setting of Safety DevicesExcept as provided in API 620 tank 9.5 for certain liquid relief valves, the pressure setting of a pressure-relieving device shall in no case exceed the maximum pressure that can exist at the level where the device is located when the pressure at the top of the tank equals the nominal pressure rating for the tank (see API 620 tank 5.3.1) and the liquid contained in the tank API standard 650 self-anchored tank is at the maximum design level.Vacuum-relieving devices shall be set to open at such a pressure or partial vacuum that the partial vacuum in the tank cannot exceed that for which the tank is designed when the inflow of air (or other gas or vapor) through the device is at its maximum specified rate.

Structural features of API 650 double-layer oil tank: steel glass fiber reinforced plastic double-layer structure, special processing method is adopted between the API standard 650 self-anchored tank internal steel shell and glass fiber reinforced plastic layer, so that a gap of 0.1 mm is created between the internal and external layers. Even if the API 650 oil storage tank leaks, it can ensure that the contained dangerous substances only flow in the gap, and will not immediately overflow the external environment.