API standard 650 ground supported flat-bottom tanks coating

The API standard 650 ground supported flat-bottom tanks must go through strict inspection before putting into use. Inspection of plate groove of API standard 650 ground supported flat-bottom tanks, vertical oil tank: After finishing the groove processing of oil tank plate, it is necessary to conduct dye penetrant inspection on the groove. This process is mainly aimed at the hard damage of groove in the machining process and the defects of the plate itself. If any defect is found, it shall be processed again until the defect disappears.Surface Inspection of low-pressure storage tank Component PartsBefore assembly, unless already so certified by shop inspectors, all sidewall plates or sections and roof and bottom plates shall be inspected for thickness, freedom from injurious defects, and soundness of any welded joints.Check of Dimensions of API standard 650 ground supported flat-bottom tanks Component PartsAll formed plates and curved sections shall be checked for conformance with the planned dimensions and cross section. For unusual repairs the inspector should keep a record of measurements taken at sufficient intervals to constitute a satisfactory record.Check of Chemical and Physical Property DataThe inspector shall check the material being assembled by the lists of the plates from the mill, their heat numbers, chemical analyses, and mechanical properties as given on mill reports and shall see that copies are available to be attached to the Manufacturer’s report.If additional requirements are met, higher internal pressures are allowed. API 650 only covers tanks that support the whole bottom evenly and API standard 650 ground supported flat-bottom tanks tanks in non-refrigerated service that have a maximum design temperature of 200 degrees F. It requires that you have a minimum material thickness of 3/16 inch.Customer concept: customer first. Guided by market changes and guided by customer needs, we design the optimal product solutions and provide the best after-sales service. Partners: to reach a balance of interests with all stakeholders, to build a harmonious coexistence and win-win cooperation.We are known as API standard 650 ground supported flat-bottom tanks leading manufacturers, suppliers and exporters in the market all over the world. We engage in providing a wide range of plates which are accurately mass produced by using the best quality of parts which gives maximum durability and dependability. The most important thing to know as a potential customer of IRON&STEEL is that we API standard 650 ground supported flat-bottom tanks stock, processing service, and distribute all of the popular grades of carbon steel plate, alloy steel, shipbuilding steel and boiler steel. Welcome to come China and visit our factory.