API 650 open-top tanks top-angle attachment for self-supporting roofs
Standard Hydrostatic and Pneumatic TestsAfter erection is completed and stress relieving, radiographic examinations, or other similar operations, as may be required, are performed, each tank shall satisfactorily pass a series of hydrostatic and pneumatic tests as prescribed in 7.18.2 through 7.18.6. Whenever a solution film is specified in this section to be applied to welding, linseed oil or another equivalent material for disclosing air leakage may be substituted. In freezing weather, linseed oil or a similarly suitable material shall be used.The attachment welding around all openings and their reinforcements in the walls of the API 620 tank shall be examined by the magnetic-particle method both inside and outside the tank API 650 open-top tanks. When the underside of a tank bottom rests directly on the tank grade (and is not accessible after erection), such examination of welding on the underside of the bottom and subsequent air testing may be omitted.
Selection of nominal diameter D of API 650 storage tank. In the design calculation of API 650 storage tank, the bottom plate thickness is the net plate thickness, that is, the actual thickness minus the corrosion allowance. In the design and calculation of API 650 open-top tanks wall thickness in hydrostatic test, the thickness of bottom plate is the total thickness of steel plate.
Bangladesh is an important market to us. We cooperated with the National Railway, the National Tubes Limited (NTL) and so on state-owned enterprises. They have tenders regularly. And we would participate the tenders with our local agents. We have been the winner of NTL tenders for many times. API 5L grade B steel strips are their needed API 650 open-top tanks materials. They have special chemical composition, tolerance and so on requirements. We can fully meet their demands and guarantee timely delivery.
}Operation points of sand blasting rust removal for metal storage tank, API 650 open-top tanks:1. The equipment should be as close as possible to the workpiece to be processed, so as to reduce the pipeline length and pressure loss, avoid excessive pipeline wear, and facilitate the construction personnel to contact each other.2. The jet pipe should be straight as much as possible to reduce the concentrated wear at the bend. The wear direction of the bend should be changed frequently to prolong the service life of the pipe.3. Strictly control the process parameters.
The after-sales service personnel understand the user's ideas and needs in detail, and stand on the other side's position and interests. Actively communicate with users and help them solve practical problems. This not only solves the service problem, but also improves the customer's trust in the company.
