API 650 mixed material tanks primary seals

API 650 mixed material tanks Manhole: The manhole is used for the operator to enter and exit the oil tank for inspection, cleaning and repair. For the convenience of personnel access, the installation position of the manhole is generally on the center line of the oil tank bottom, and the vertical oil tank is installed at the lowest layer of the tank wall. API 650 mixed material tanks Light-transmitting hole: Light-transmitting hole is also called day-lighting hole. It is used for lighting and ventilation when inspecting, repairing and scrubbing the oil tank. It is generally installed on the top of the oil tank above the inlet and outlet pipes.

Under the action of the earthquake, API 650 storage tank is mainly damaged by the phenomenon of the lower part of the API 650 mixed material tanks tank wall. Therefore, the key point of seismic calculation is to prevent the tank wall from buckling under axial pressure.

The company attaches great importance to logistics services, sets up our own transport truck fleet, improves customer response capacity through the improvement of logistics capacity, and further reduces costs. Customers ordering API 650 mixed material tanks steel from our company can not only enjoy the service of fast delivery, but also enjoy lower transportation costs. Fast, accurate, simple and efficient has always been our principle.

Any joints between the adjacent sections of API 620 oil storage tank stiffening rings, as shown in Figure Q-1, shall be made so that the required moment of inertia of the combined ring-shell section is provided. Weld joints between adjacent sections shall be made with full-thickness and full-penetration butt-welds. Stiffening-ring butt-welds may employ metal backing strips. Backing strips and the associated welding shall be made in a manner that provides a smooth contour in the rat hole and all other weld joint ends. All weld passes shall be started at the rat hole and other weld joint ends and shall be completed by moving away from these ends. Passes shall be overlapped away from edges to provide a smooth continuous weld.