API 650 mechanically-anchored steel tanks in SUG III

The company regularly holds sales elites to share experiences, to promote the rapid growth of colleagues, and achieve the company and employees. The company conducts employee skill training and related knowledge video learning from time to time. All these things is to improve the employees' skills and literacy, and reflects its own value. It has always been the pursuit of BBN steel to enhance the employee’s ability and keep up with the times.Material for the outer tank API 650 mechanically-anchored steel tanks and for the roof that contains the vaporized liquefied gas but is primarily subjected to atmospheric temperatures may conform to one of the following:
a)Table 4-1 for design metal temperatures down to –35°F (lowest 1-day mean ambient temperature of–35°F) without impact test unless they are required by Table 4-1 or by the Purchaser.
b)Table R-3 for design metal temperatures down to –60°F without impact tests unless they are required by Table R-4 or by the Purchaser.API 650 petroleum storage tanks use lightning protection, anti-static, and fire protection measures. The internal corrosion protection should be determined according to the API 650 mechanically-anchored steel tanks storage medium, and the outer wall corrosion protection should be determined according to the soil quality of the buried tank.Strengthen system construction. The system itself has a certain binding force, which specifies the rights and obligations of employees. It is a passive management means for employees. Its purpose is to promote each employee to develop good professional habits, form good behavior norms, and promote the improvement of enterprise management level.Requirements for prefabrication of the top of large vertical API 650 mechanically-anchored steel tanks: The prefabrication of the tank top shall be prefabricated in blocks according to the drawings. Pay attention to the spacing of the welds after installation when setting out the material. Reinforcing ribs should be formed and inspected with an arc-shaped template. When a single top plate needs to be spliced, butt joints should be used. The forming of a single top plate should be welded between the reinforcing ribs and the top plate on the mould. After forming, check with an arc-shaped sample plate, and the gap should not be greater than 10 mm.