60ft diameter API 650 partially anchored liquid-storage tanks
According to API 650 tanks, anchoring devices should be designed to transfer overturning moments to the API 650 partially anchored liquid-storage tanks tank foundation. At the same time, according to API 650 tank Appendix F, when the tank is to be anchored, the size of the anchoring parts is determined by the maximum lifting force caused by the internal pressure and wind load or the combination of internal pressure and seismic load.
The company's after-sales service tenet is "customer first, timely guarantee, enthusiastic service and effective work". In order to establish a set of perfect after-sales service system and strict management system, so that the after-sales service can be effectively guaranteed. The company has set up after-sales service department to ensure timely, unique and effective response to every user's request, coordinate internal resources internally, and put an end to all evasion and delay.
Steel Storage Tanks Cover Plates MaterialASTM A516 Gr 55 Carbon Steel Pressure Vessel Plates for API 650 partially anchored liquid-storage tanksASTM A285, Pressure Vessel Plates for Low- and Intermediate-Tensile StrengthASTM A307 Carbon Steel Bolts and StudsASTM A320 Alloy Steel Bolting Materials for Low-Temperature ServiceASTM A333 Seamless and Welded Steel Pipe for Low-Temperature ServiceASTM A334 Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature ServiceASTM A350 Forgings, Carbon and Low-Alloy Steel for Piping ComponentsASTM A351 Castings for Pressure-Containing PartsASTM A353 Pressure Vessel Plates, Alloy Steel
The API 650 partially anchored liquid-storage tanks must go through strict inspection before putting into use. Inspection of plate groove of API 650 partially anchored liquid-storage tanks, vertical oil tank: After finishing the groove processing of oil tank plate, it is necessary to conduct dye penetrant inspection on the groove. This process is mainly aimed at the hard damage of groove in the machining process and the defects of the plate itself. If any defect is found, it shall be processed again until the defect disappears.
