6063 aluminum shapes API standard 650 mixed material tanks

Heat-affected zone impact specimens shall be taken across the weld and as near the surface of the material as is practicable. The API standard 650 mixed material tanks material specimens shall be of sufficient length to locate the notch in the heat-affected zone after etching. The notch shall be cut approximately normal to the material surface to include as much heat-affected zone material as possible in the resulting fracture. Impact test specimens shall be cooled to the temperature stated in Q.22.Test welds of each API 650 tank nozzle and manway reinforcing pad (or each section of multiple piece pad) using dry air and apply a soap solution test in the presence of Purchaser's Inspector before hydro testing the API standard 650 mixed material tanks tank. Tap one inch NPT test hole in each pad or section.The Egypt customer ordered 130 tons API standard 650 mixed material tanks stainless steel plate in stock, and this batch has left port today for its destination today(October 25th, 2019). 316l stainless steel is molybdenum-bearing austenitic stainless steel. This material has better corrosion resistant property than 304/314L for it's higher Ni and Mo content. (it is considered to be marine grade stainless steel, not suitable for warm sea water treatment). 316L austenitic stainless steel supplied by our company has good formability and weldablity, additionally it is proved to have excellent properties of tensile, creep and stress-rupture strengths in elevated temperature environment.Atmospheric API standard 650 mixed material tanks refer to storage tanks whose gas or vapor pressure is greater than -0.02MPa but less than 0.1MPa. Metal atmospheric storage tanks made of steel welded on the ground are often used to store petroleum, chemical and other similar liquids. Atmospheric API standard 650 mixed material tanks usually have a connecting pipe directly connected to the atmosphere, so that the operating pressure in the storage tank does not exceed the design pressure at all times.After the order is finished, our after-sales service center will send an email to make a feedback about our steel products' quality. We have phone service every three months to remind our customers of the possible problems and collect advices or suggestions in quality and service. Upon the collection of advices or suggestions, our after-sales service will quickly make technical solutions to wipe out the customer problem.