5456 aluminum shapes API Std 650 larger diameter tanks

Our team is a dynamic, but also mature and steady team. The talents are made of different ages. There are experienced ones, and also creative ones, that also makes our company culture diversified. We have complete department structure, to make the whole work procedure run smoothly. For every step, we have special person to be in charge and responsible for our customer and update information to the customer in time. So you just need not worry too much to purchase steel materials from our company.

The process parameters should be strictly controlled in sand blasting of API Std 650 larger diameter tanks. The working pressure of abrasive chamber is between 0.5 and 0.6a, and the outlet pressure of air compressor shall not be lower than 0.6 WPa. According to the test results, the distance between nozzle and workpiece shall be controlled at 80 - 200 mm and spraying angle of 30 ~ 75°is appropriate.

The increased uplift described in API Standard 620 tank Appendix Q is intended to apply to the size of the ringwall and foundation but not the anchorage. For tanks with an internal design pressure of 1 lbf/in.2 gauge and over, the uplift, if any, shall be calculated under the combined conditions of 1.25 times the internal design condition plus the design wind load on the API Std 650 larger diameter tanks shell and roof.