5052 aluminum bar API standard 650 mixed material tanks
The horizontal projection of the roof plate within the compression-ring region is 4.9 x 0.866 = 4.25 in., which fulfills the requirement of API 620 tank standard 5.12.5.1. The required area and horizontal projection can be provided by any of the standard angles listed in Table F-3.Any of these angles may be used in accordance with the details of Figure 5-6, detail a or b, but if details c, h, or i in Figure 5-6 were intended, the net area of the angle must be calculated by deducting the area expected to be lost by corrosion from that part of the angle surface that is exposed to the interior of the tank.
API 650 petroleum storage tank body design is mainly the design of tank bottom, API standard 650 mixed material tanks tank top and tank wall, and the design of tank wall is particularly important. As the main pressure bearing part of API 650 petroleum storage tank, the tank wall bears loads including liquid pressure, wind pressure, seismic load, opening stress, etc. The calculation of such loads is explained in detail in various API standard 650 mixed material tanks storage tank design standards. But in addition, the API 650 petroleum storage tank wall also bears the push-pull force and torque of the connected pipeline.
We have lots of successful cases, for example in July 2015, we exported 5714 tons ASTM A36 mild steel plate to Peru. After receiving the plates and putting then into use, our customer spoke highly of the ASTM A36 mild steel plate quality. In addition, the customer also introduced us an Venezuela customer, who bought 933 tons A36 steel API standard 650 mixed material tanks plate from us. And then in Mar. 2016, due to the first cooperation in July 2015 is very successful. The customer is very satisfied with our product quality and comprehensive service. This time, the customer place an 3989 tons order directly.
}API standard 650 mixed material tanks construction must adhere to the design drawings, acceptance specifications and construction plans. If the design needs to be modified during API standard 650 mixed material tanks construction, it must be approved by the original design unit or Party A’s representative and relevant personnel of the supervision unit, and written visa procedures must be completed in advance. The equipment and main materials used in the oil tank construction project must have certificates of conformity and quality assurance.
We should help solve the customer's problems in time, not just verbally, without solving the problems or shirking the responsibility. Improving after-sales efficiency can make customers feel respect. We should take their problems seriously and show sincerity. It can also give customers a good impression and reduce the negative impact.
