35ft diameter API 650 ground supported flat-bottom tanks

The API 650 ground supported flat-bottom tanks stiffener ring and backing strip (if used) are primary components, and they shall comply with the requirements of API 620 storage steel tank Q.2.1. The stiffener rings may be fabricated from plate using an intermittent weld on alternating sides between the web and the flange.
Except for aluminum or stainless steel tanks, all fillet welds shall consist of a minimum of two passes. The ends of the fillet welds shall be 2 in. from the rat hole (see Figure Q-1), and these welds shall be deposited by starting 2 in. from the rat hole and welding away from the rat hole. An acceptable alternative to the detail that includes stopping fillet welds 2 in. short of the rat hole would be to weld continuously through the rat hole from one side of the stiffener to the opposite side. All craters in fillet welds shall be repaired by back welding.

API 650 petroleum storage tank stipulates that if the thickness of the lower siding obtained by calculating the anti-overturning moment is greater than the thickness of the API 650 ground supported flat-bottom tanks hydrostatic pressure test (both do not include the corrosion margin), the calculated thickness of the above siding required by the hydrostatic pressure is It should also be increased by the same proportion, unless special analysis is performed to determine the seismic overturning moment and corresponding stress at the bottom of each layer of API 650 petroleum storage tank wall.

In 2015, we offered 230 tons 309S and 310S stainless steel API 650 ground supported flat-bottom tanks plate to Vietnam fabrication company. The products are used in fabricating machine for this company. Then the customer sell the machine to south America and European market. This Vietnam company purchase more than 100 ton stainless steel from us every month.

The heat transfer oil fin tube heating device for large API 650 ground supported flat-bottom tanks heats the circulating heat transfer oil in the shell and tube heat exchanger through high temperature and high pressure steam. The heat transfer oil exchanges heat with the medium to be heated in the storage tank through the heating coil, so as to heat the storage medium. High temperature heat transfer oil fin tube heating device has the following advantages:
1. High heat transfer efficiency
2. Reduce heating coil leakage
3. Easy to repair and maintain

From the order to the delivery, there are three quality inspections to ensure that the qualified rate of finished products is more than 100%. We promise that every order will be tracked in a timely manner to ensure that customers can receive goods safely and constantly listen to their opinions and suggestions, reflect on our own problems, and let customers feel at ease. We have a large warehouse in Shanghai and Tianjin, which can provide customers with sufficient sources of supply.