welded tanks for oil storage cylindrical side wall sections

We can process the steel materials according to your drawing. Or if you can not make drawing, please send us welded tanks for oil storage specific data and requirements, our technical department can make design and drawing for you, and then confirm with your technician or engineer. If all is OK, our processing center will process the steel materials according to the drawing. So no matter what size and shapes you need, we can meet demands at the most time.

Surface Inspection of low-pressure storage tank Component PartsBefore assembly, unless already so certified by shop inspectors, all sidewall plates or sections and roof and bottom plates shall be inspected for thickness, freedom from injurious defects, and soundness of any welded joints.Check of Dimensions of welded tanks for oil storage Component PartsAll formed plates and curved sections shall be checked for conformance with the planned dimensions and cross section. For unusual repairs the inspector should keep a record of measurements taken at sufficient intervals to constitute a satisfactory record.Check of Chemical and Physical Property DataThe inspector shall check the material being assembled by the lists of the plates from the mill, their heat numbers, chemical analyses, and mechanical properties as given on mill reports and shall see that copies are available to be attached to the Manufacturer’s report.

The welded tanks for oil storage must go through strict inspection before putting into use. Inspection of plate groove of welded tanks for oil storage, vertical oil tank: After finishing the groove processing of oil tank plate, it is necessary to conduct dye penetrant inspection on the groove. This process is mainly aimed at the hard damage of groove in the machining process and the defects of the plate itself. If any defect is found, it shall be processed again until the defect disappears.

The strip steel thickness is generally below 6mm, which is convenient for crimping and processing. You should choose the welded tanks for oil storage, strip steel specifications according to your own purposes. The specifications and materials used for different purposes are different, so you must confirm it before buying. It is best to ask professionals to give advice before purchasing strip steel, and purchase the specifications and types you need according to the corresponding requirements.