Typical sizes of API standard 650 horizontal tank

We can process the steel materials according to your drawing. Or if you can not make drawing, please send us API standard 650 horizontal tank specific data and requirements, our technical department can make design and drawing for you, and then confirm with your technician or engineer. If all is OK, our processing center will process the steel materials according to the drawing. So no matter what size and shapes you need, we can meet demands at the most time.The materials used in the construction of Appendix Q oil tanks may be subject to severe pitting, cracking, or rusting if they are exposed to contaminated test water for extended periods of time. The Purchaser shall specify a minimum quality of test water that conforms to Q.8.3.2 through Q.8.3.8. After the water test is completed, the tank API standard 650 horizontal tank shall be promptly drained, cleaned, and dried.For areas with high groundwater levels, the operator should take anchoring and anti-floating measures for buried horizontal API standard 650 horizontal tank oil tanks; API 650 oil tanks can be used for heavy fuel oil, heaters are separately designed, and buried tank material outlets are installed with bottom valves and connections considerThe company operates on the principles of fairness, objectivity, science, pragmatism and integrity The management treats people with courtesy, takes sincerity as the standard management, dares to open up, unites and advances, carries on the past and makes unremitting efforts, seizes the good trend of economic development, strengthens exchanges with peers, makes friends with all walks of life, keeps pace with the times and creates greater brilliance of the enterprise, and makes its own contribution to the prosperity and development of the steel industry,API standard 650 horizontal tank. weld tightness test: remove dirt from the API standard 650 horizontal tank weld, apply white powder emulsion, spray kerosene on the other side of the weld after drying. Because of the strong penetration of kerosene, if kerosene is sprayed after 12 hours (under low temperature conditions, the time can be extended), if the surface of the welded seam coated with white emulsion has no spots, the welded seam meets the requirements.