EN 10025 S275J2 plates API standard 650 flat-bottom oil storage tanks

Treatment of API standard 650 flat-bottom oil storage tanks welding defects:
1. Lack of fusion: once found, it should be shoveled and grinded off before re welding.
2. Incomplete penetration: over standard defects shall be removed and re welded. When welding on both sides, the shallow side of the groove can be grinded and shoveled to expose the welding root on one side, and then the welding is repaired.
3. Slag inclusion: over standard defects shall be removed and re welded.
4. Crater: weld to full after grinding.
5. Air hole: if the internal air hole exceeds the standard, it shall be welded again after being removed by grinding shovel, and the surface air hole shall be removed by grinding wheel and then repaired.Thickness as it Affects Preheat and Post-heat Requirements
Plate with thicknesses below 1/2 in. is reasonably notch tough. In most steels, when the API standard 650 flat-bottom oil storage tanks used plate thickness exceeds 3/4 in. – 1 in., notch toughness, particularly as welded, decreases sharply. The decrease in notch toughness can be minimized by the conventional post-heat treatment and, in many steels, by preheat treatment. The benefits of preheat treatment in steels 3/4 in. – 1 in. thick have been demonstrated; similar benefits could be expected in thicker steels, but sufficient experimental data are currently lacking.All edges of the inner wall of the API 650 petroleum storage tank to be lined or coated must be rounded and flat to a minimum radius of 3mm. The API standard 650 flat-bottom oil storage tanks internal welding seam must be completely sealed welding, with a smooth surface and no air holes, air pockets and local protrusions. Remove welding spatter. As specified in API 650 petroleum storage tank design drawings, the seller must perform additional surface treatment.The API standard 650 flat-bottom oil storage tanks company has established the corporate values of being proud of innovation and winning, and successfully realized the management of corporate culture. In BBN, leaders are not controllers and supervisors, but earnest API standard 650 flat-bottom oil storage tanks teachers, coaches and enthusiastic friends, so that employees can have more democracy, more autonomy, independence and creativity, and the belief of winning.The consistent tenet of honest management! Know the needs of customers, for the needs of customers, urgent customers think! Our quality is better for the API standard 650 flat-bottom oil storage tanks same products, our price is lower for the same quality, and our service is better for the same price. welcome to purchase steel materials from our company. we have the professional team and good after-sale system to customers. our company API standard 650 flat-bottom oil storage tanks is your best choose.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!