CSA G40.21 Gr 38WT plates API Std 650 aluminum tanks

Thickness as it Affects Preheat and Post-heat Requirements
Plate with thicknesses below 1/2 in. is reasonably notch tough. In most steels, when the API Std 650 aluminum tanks used plate thickness exceeds 3/4 in. – 1 in., notch toughness, particularly as welded, decreases sharply. The decrease in notch toughness can be minimized by the conventional post-heat treatment and, in many steels, by preheat treatment. The benefits of preheat treatment in steels 3/4 in. – 1 in. thick have been demonstrated; similar benefits could be expected in thicker steels, but sufficient experimental data are currently lacking.

The effect of air pressure on the API Std 650 aluminum tanks tank walls of the API 650 tank must be considered when the design pressure is greater than 2 kPa.The fixed point method can be used to design the tank wall of atmospheric or micro internal pressure API Std 650 aluminum tanks storage tank.

A Uganda client purchased 2100 tons SG255 gas cylinder steel coils in 2018. It is the first company in Uganda to provide re-furbishing, re-certification and manufacturing of new lpg cylinders. They have regular demands for sg255 coils API Std 650 aluminum tanks every 3 months. Limited by inland location, we can only ship container to mombasa, and then transfer to kampala. OurJISG3116 SG255 steel product is grade for gas cylinder steel with the tensile strength of 400MPa and the yield strength of 255MPa.

Requirements for prefabrication of the top of large vertical API Std 650 aluminum tanks: The prefabrication of the tank top shall be prefabricated in blocks according to the drawings. Pay attention to the spacing of the welds after installation when setting out the material. Reinforcing ribs should be formed and inspected with an arc-shaped template. When a single top plate needs to be spliced, butt joints should be used. The forming of a single top plate should be welded between the reinforcing ribs and the top plate on the mould. After forming, check with an arc-shaped sample plate, and the gap should not be greater than 10 mm.

The after-sales service department will pay return visit to each customer by call or email, report problems found during the return visit in time, and discuss with the production and quality inspection center to propose effective solutions and follow up in a timely manner, so as to ensure the benefits each customer are fully guaranteed, and to provide customers with more value-added services.