API Std 650 SUG II tanks manual welding

Our quality control department will do inspection for details of the steel materials API Std 650 SUG II tanks before delivery. We would invite the customer side to attend the inspection together. If they can not come, we will also take rich pictures for them to check. Meanwhile, we will publish inspection report and send them the PDF version. Besides, we accept any third party inspection such as SGS, BV, etc. And our quality control department will support the third party to inspect the steel materials smoothly and try our best to deliver the qualified steel materials to customers earlier.

In the actual welding of API Std 650 SUG II tanks, operators will use more arc-shaped plates for tailor-welding to better adapt to the larger volume of oil storage tanks. In order to effectively control the deformation of the welding seam of the API Std 650 SUG II tanks, a scientific and accurate prefabricated bottom plate is required. In the process of prefabricating the bottom plate of the oil storage tank, it is necessary to strictly follow the technical requirements for the construction of the oil storage tank. At the same time, it is also necessary to clarify the external dimensions according to its actual manufacturing standards so that it has sufficient shrinkage.

The horizontal projection of the roof plate within the compression-ring region is 4.9 x 0.866 = 4.25 in., which fulfills the requirement of API 620 tank standard 5.12.5.1. The required area and horizontal projection can be provided by any of the standard angles listed in Table F-3.
Any of these angles may be used in accordance with the details of Figure 5-6, detail a or b, but if details c, h, or i in Figure 5-6 were intended, the net area of the angle must be calculated by deducting the area expected to be lost by corrosion from that part of the angle surface that is exposed to the interior of the tank.