API Std 650 self-anchored flat-bottom tanks threaded connections

It is very important for an enterprise to have a sound after-sales service system, which not only ensures the normal outflow and inflow of the company's products, but also improves the trust of the company's products in the hearts of customers. Our company has a special after-sales service team and good after-sales service reputation. In case of any problem in the use of our steel products API Std 650 self-anchored flat-bottom tanks , whether quality problem or not, the after-sales service department will assist in solving the problem as soon as possible, and regularly consult and track the use of the steel products,API Std 650 self-anchored flat-bottom tanks. Liquid Relief ValvesA tank, which is likely to operate completely filled with liquid, shall be equipped with one or more liquid relief valves at the top of the roof, unless otherwise protected against overpressure. When such valves are, in effect, supplementary relief devices, they may be set at a pressure not greater than 1.25 times the design pressure. Because the relief valve at the pump, which provides the inflow of liquid to the tank, is set at a pressure greater than 1.25 times the design pressure of any tank that may be built under these rules, provision should be made for preventing overfilling of the tank by a self-closing float valve, by some practicable pilot-valve control, or by any other proven device.API 650 is an American standard for welding flat bottom vertical storage tanks. This API Std 650 self-anchored flat-bottom tanks standard specifies requirements for the design, manufacturing, welding, inspection and installation of storage tanks. API 650 is widely used in storage tanks designed to withstand low internal pressures and used to store typical products such as API Std 650 self-anchored flat-bottom tanks crude oil, gasoline, chemicals and water. BBN has extensive experience in API 650 tanks, from +/- 500 cubic meters of tanks produced in the factory to +/- 15000 cubic meters of tanks produced on site."Hard and solid, honest commitment, practical effect". To strive for a solid enterprise foundation with hard work style; to promise first-class enterprise service with honest faith; to create efficient enterprise performance with practical spirit.Requirements for prefabrication of the top of large vertical API Std 650 self-anchored flat-bottom tanks: The prefabrication of the tank top shall be prefabricated in blocks according to the drawings. Pay attention to the spacing of the welds after installation when setting out the material. Reinforcing ribs should be formed and inspected with an arc-shaped template. When a single top plate needs to be spliced, butt joints should be used. The forming of a single top plate should be welded between the reinforcing ribs and the top plate on the mould. After forming, check with an arc-shaped sample plate, and the gap should not be greater than 10 mm.