API Std 650 petroleum storage tanks size

Thickness as it Affects Preheat and Post-heat Requirements
Plate with thicknesses below 1/2 in. is reasonably notch tough. In most steels, when the API Std 650 petroleum storage tanks used plate thickness exceeds 3/4 in. – 1 in., notch toughness, particularly as welded, decreases sharply. The decrease in notch toughness can be minimized by the conventional post-heat treatment and, in many steels, by preheat treatment. The benefits of preheat treatment in steels 3/4 in. – 1 in. thick have been demonstrated; similar benefits could be expected in thicker steels, but sufficient experimental data are currently lacking.

For areas with high groundwater levels, the operator should take anchoring and anti-floating measures for buried horizontal API Std 650 petroleum storage tanks oil tanks; API 650 oil tanks can be used for heavy fuel oil, heaters are separately designed, and buried tank material outlets are installed with bottom valves and connections. consider.

In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.

Requirements for prefabrication of the top of large vertical API Std 650 petroleum storage tanks: The prefabrication of the tank top shall be prefabricated in blocks according to the drawings. Pay attention to the spacing of the welds after installation when setting out the material. Reinforcing ribs should be formed and inspected with an arc-shaped template. When a single top plate needs to be spliced, butt joints should be used. The forming of a single top plate should be welded between the reinforcing ribs and the top plate on the mould. After forming, check with an arc-shaped sample plate, and the gap should not be greater than 10 mm.

The company conducts periodic and targeted training and guidance for after-sales service personnel. As the saying goes, "no one is perfect, no gold is red", to help after-sales service personnel improve service skills and correct service attitude. Carry out relevant technical training for after-sales service personnel, so that after-sales service practitioners have professional product knowledge.