API Std 650 mechanically-anchored steel tanks design

The thickness of the API Std 650 mechanically-anchored steel tanks annular bottom plates shall be in accordance with Table Q-4 (for steel or aluminum, as applicable). The thicknesses shown are minimums. The ring of annual plates shall have a circular outside circumference, but it may have a regular polygonal shape inside the tank shell with the number of sides equal to the number of annular plates. These pieces shall be butt-welded in accordance with Q.7.1.1, Item b. The plates of the first shell course shall be attached to the annular bottom plates by a weld as required by API 620 oil tank 5.9.5 except when a full-penetration weld is used or required (see Q.7.1.1). Butt-welds in annular plates shall be not closer than 12 in. from any vertical weld.

In API 650 oil storage tank, when the mixing ratio of combustible medium and air reaches a certain limit, it is easy to cause explosion. Therefore, it is necessary to add API Std 650 mechanically-anchored steel tanks external floating roof to open cylindrical steel API Std 650 mechanically-anchored steel tanks tank. At present, the external floating roof is most suitable for large-scale API 650 oil storage tank in China, ranging from 20000, 30000, 50000 cubic meters to 100000 cubic meters.

1200 tons API 5LGRB strips to Bangladesh. In December of 2015, we get one tender project from National Tubes Limited, which is a famous national enterprise in Bangladesh. It is an order of 1200 tons API 5L Gr. B steel strips, they bought these cargo to fabricate ERW pipe in local place.

The heat transfer oil fin tube heating device for large API Std 650 mechanically-anchored steel tanks heats the circulating heat transfer oil in the shell and tube heat exchanger through high temperature and high pressure steam. The heat transfer oil exchanges heat with the medium to be heated in the storage tank through the heating coil, so as to heat the storage medium. High temperature heat transfer oil fin tube heating device has the following advantages:
1. High heat transfer efficiency
2. Reduce heating coil leakage
3. Easy to repair and maintain

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.