API Std 650 flat-bottom steel tanks envelope seals

The inner and outer tanks may be decoupled for seismic design of the tank and anchorage and assumed to act independently. However, if the inner and outer tanks API Std 650 flat-bottom steel tanks are supported by a common foundation, the seismic foundation loading shall be calculated using the lesser response modification values for either the inner tank or outer tank for both tanks and a dynamic analysis shall be performed to determine the combined effect.
Allowable Stresses: For Appendix R tanks, design allowable stresses shall be per API 620 large low pressure storage tank, Section R.3.3.

API 650 petroleum storage tank stipulates that if the thickness of the lower siding obtained by calculating the anti-overturning moment is greater than the thickness of the API Std 650 flat-bottom steel tanks hydrostatic pressure test (both do not include the corrosion margin), the calculated thickness of the above siding required by the hydrostatic pressure is It should also be increased by the same proportion, unless special analysis is performed to determine the seismic overturning moment and corresponding stress at the bottom of each layer of API 650 petroleum storage tank wall.

In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.

The heat transfer oil fin tube heating device for large API Std 650 flat-bottom steel tanks heats the circulating heat transfer oil in the shell and tube heat exchanger through high temperature and high pressure steam. The heat transfer oil exchanges heat with the medium to be heated in the storage tank through the heating coil, so as to heat the storage medium. High temperature heat transfer oil fin tube heating device has the following advantages:
1. High heat transfer efficiency
2. Reduce heating coil leakage
3. Easy to repair and maintain

Both parties shall confirm the API Std 650 flat-bottom steel tanks material object and the quality of the products, confirm the reasons for the defects and the quality of the products, and sign the quality inspection agreement. Major quality objections shall be reported to relevant leaders in a timely manner, and shall be discussed and solved with the API Std 650 flat-bottom steel tanks steel plant.