API Std 650 aboveground petroleum storage tanks restrictions on joints

The horizontal projection of the roof plate within the compression-ring region is 4.9 x 0.866 = 4.25 in., which fulfills the requirement of API 620 tank standard 5.12.5.1. The required area and horizontal projection can be provided by any of the standard angles listed in Table F-3.
Any of these angles may be used in accordance with the details of Figure 5-6, detail a or b, but if details c, h, or i in Figure 5-6 were intended, the net area of the angle must be calculated by deducting the area expected to be lost by corrosion from that part of the angle surface that is exposed to the interior of the tank.

storage tanks API Std 650 aboveground petroleum storage tanks designed in accordance with the rules and guidelines of API 650 are called API 650 storage tanks. API 650 is a control rule for welded storage tanks that work normally in the normal pressure range.

Oil tank is often used to store crude oil, diesel oil, gasoline and other oil. The main structure of API Std 650 aboveground petroleum storage tanks is composed of tank top, tank wall, tank bottom and accessories. The API Std 650 aboveground petroleum storage tanks should be inspected after the completion of construction, and the detection methods of different structure positions are different. Tank wall inspection: for the newly built oil tank, water filling test shall be conducted to check whether the tank wall is tight, and the appearance inspection shall be conducted for the tank wall plate and weld. Tank wall thickness detection: the oil tank wall thickness is mainly detected by ultrasonic wave, with high efficiency.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!