API standard 650 welded storage tanks machine welding

As an experienced world class steel materials supplier and exporter, logistics and fast delivery is a crucial step to us. Our logistics department and shipping department take the responsiblity to allocate and transport steel materials from our mill and warehouse to customer port or designated destination. The cooperation of the two departemts are excellent and that powerfully support our fast delivery, and strive for shorter time for customers to receive steel materials.Welding of Large Steel storage tank Primary Components
a)Longitudinal and circumferential shell joints and joints that connect the API standard 650 welded storage tanks annular bottom plates together.
b)Joints that connect sections of compression rings and sections of shell stiffeners together. Backup bars may be used for these joints with complete penetration and complete fusion detail.
c)Joints around the periphery of a shell insert plate.
d)Joints that connect the shell to the bottom, unless a method of leak checking is used (see Q.8.2.1).For API 650 tanks Projection from outside of tank shell to extreme face of flange - plus or minus 5 mm. API standard 650 welded storage tanks Elevation or radial location - plus or minus 6 mm. API 650 tanks Flange tilt in any plane, measured on the diameter across the gasket surface - plus or minus degree but not exceeding 5 mm. Flange bolt hole orientation - plus or minus 2 mm.Management concept: abide by laws, regulations and social norms. To improve the system of management, to carry out activities with high corporate ethics. Mutual respect, unity and harmony, create a "fair, just and open" good working environment for employees. Forge ahead, constantly pursue new technology innovation, create social value, and become a sustainable growth enterprise.Deformation of the welding seam of the API standard 650 welded storage tanks is a common quality problem during the actual use of the API standard 650 welded storage tanks, which easily causes the tank body to leak and affects the safety of the oil storage tank. The welding seam deformation of the API standard 650 welded storage tanks is mainly caused by the lack of reserved welding seam gap and irregular operation. The oil storage tank has not reserved the corresponding weld gap, resulting in deeper root removal during the front welding activity. The heat output of the weld will increase under the influence of a long time, and the deformation of the weld will gradually become serious.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!