API standard 650 storage tanks roof support legs

The density of the liquid API 620 large welded, low pressure storage tanks stored shall be its maximum density within the range of design temperatures, but no less than 36 lbf/ft3. The maximum allowable tensile stress shall be taken from Table 5-1 or Table Q-3. For the maximum allowable stresses for design loading combined with wind or earthquake loads, see API Standard 620 5.5.6 for carbon steel and Q.3.3.5 for stainless steel and aluminum.The working pressure of the low-pressure storage tank is greater than that of the atmospheric storage tank, but its pressure is less than 0.1MPa. API 650 petroleum storage tanks are classified according to their environment: Above-ground storage tank: refers to the bottom of the storage tank at the design elevation of API standard 650 storage tanks and above; the bottom of the tank is below the design elevation of +0.00 but not exceeding.In April 2018, our Philiphine customer purchased 1008 Tons API5 L Gr.B ERW&Q345B SMLS pipe API standard 650 storage tanks for offshore oildfield resources drilling project. This is a regular demand almost two month, and we has been cooperated more than three times, totally around 2100 tons steel pipe since 2015 year.Requirements for prefabrication of the top of large vertical API standard 650 storage tanks: The prefabrication of the tank top shall be prefabricated in blocks according to the drawings. Pay attention to the spacing of the welds after installation when setting out the material. Reinforcing ribs should be formed and inspected with an arc-shaped template. When a single top plate needs to be spliced, butt joints should be used. The forming of a single top plate should be welded between the reinforcing ribs and the top plate on the mould. After forming, check with an arc-shaped sample plate, and the gap should not be greater than 10 mm.The company formulates clear service process and service standard. To do a good job in after-sales service, first of all, clear service process and service standards should be formulated to let employees know which procedures to perform and which service standards to abide by.