API standard 650 storage tanks leg sleeves

The process parameters should be strictly controlled in sand blasting of API standard 650 storage tanks. The working pressure of abrasive chamber is between 0.5 and 0.6a, and the outlet pressure of air compressor shall not be lower than 0.6 WPa. According to the test results, the distance between nozzle and workpiece shall be controlled at 80 - 200 mm and spraying angle of 30 ~ 75°is appropriate.

The refrigerated tank primary components shall also include those parts of a single-wall or an inner tank that are not in contact with the refrigerated liquid but are subject to the refrigerated temperature. Such API standard 650 storage tanks components include roof plates, roof manways and nozzles with their reinforcements, roof-supporting structural members, and shell stiffeners when the combined tensile and primary bending stresses in these components under design conditions are greater than 6000 lbf/in.2.

The American standard API 650 design has been widely used. We can use our existing professional design knowledge to serve the construction projects of large API standard 650 storage tanks storage tanks, oil tanks and water tanks. The company is a small and medium enterprise that can provide American standard API 650 design software, design qualifications, and design capabilities.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!